11
INSTALLATION
WARNING: HEAVY EQUIPMENT. The machine weight is 400 lb. (182 kg)
Use suitable lifting procedures.
A. Once you have received your CS 326 , un-crate the unit and make a thorough inspection to
determine if any loss of contents, or damage, has occurred during shipping. Any shipping
related damage must be reported to the carrier immediately. Remove the rust protective
coating from the unpainted surfaces.
B. This equipment is designed for normal operation in a dry location where it is not likely to be
subjected to drip, splash or spray of water or other liquids. Select a suitable location for
which allows adequate perimeter access for maintenance.
C. Un-pack the monitor and place it on the upper shelf. Insert the video cable through the notch
in the back of the top cover and out the hole in the front. There is a ramp built in to the cover
to help guide the cable through the cover. Connect the power cord pigtail that extends from
the notch to the monitor. (Store the carton and packing material in the event of a failure the
monitor has to be returned in the original carton.)
D. Un-pack and install the computer.
1. Along with the computer you will find the manual and operating system disks for the
operators station PC. (Store these items along with the carton in a safe location. In the
event of a failure of this unit it will be necessary to return it along with the operating
system disks in the original carton.)
2. Set the computer on the machine.
3. On the back of the computer check to see if there is a power selection switch for
110VAC or 220VAC. If there is confirm that it is in the correct location, depending on
the voltage your machine is to be connect to.
4. Plug in the power cord to the computer.
5. Connect the video cable to the video port and secure it with the thumb screws.
6. Connect the serial cable to the COM port, the COM number on the cable and the
computer should match.
7. Plug in the mouse and place it on the right side of the computer.
8. Plug in the keyboard and place it on the sloped area at the front of the machine.
E. Insert the wire straightener bracket through the hole in the left end of the cabinet and secure it
with the screws provided.
Caution: To avoid any shock hazard do not insert the bracket into the cabinet with
electrical power on. Do not insert the bracket any further than necessary into the
cabinet as damage may occur.
To Next Page
Loading...
