6
ARTOS CS 326
WITH GRAPHIC USER INTERFACE (GUI)
CUSTOMER SAFETY NOTICE
The CS 326 B Bs supplied to you must only be used with all the guards and safety
devices in place and secure to meet the intended requirements. The safety
interlocks must not be tampered with or overridden in any way. Should any
guards, interlock, or other safety device be found to be damaged or non-operative
the machine cannot be used until appropriate repairs have been effected.
All safety guards and interlocks should be tested daily or at the beginning of each shift change. It
is recommended that these checks be documented.
SAFETY INTERLOCKS
FRONT GUARD: Opening the front guard will stop the machine and display the warning
“Front Guard Open”. The same message will appear if the MASTER START is pressed with
the guard open.
SCRAP DRAWER: Opening the scrap drawer will stop the machine and display the warning
“Scrap Drawer Open”. The same message will appear if the MASTER START is pressed with
the scrap drawer open.
SEE APPENDIX “A” FOR MORE DETAILS OF THE GUARD INTERLOCK AND
EMERGENCY STOP SYSTEM.
All electrical enclosures must be kept closed and secured. Only authorized persons with
appropriate training should access these enclosures. In the event that it is required to access
electrical enclosures with main power on, only persons properly trained and familiar with
acceptable Safety Regulations may do so.
When performing routine maintenance, adjusting, or cleaning, the machine must be electrically
isolated from the power supply.
Above all else “Think Safety” and insure that the machine is in fact safe.
To Next Page
Loading...