23
OtherTab
Batch Control – The method the machine stops at the end of each batch can be controlled in two ways.
1. In Manual the machine will re-start the next batch only when the CYCLE START button is
pressed.
2. In Timed the machine will automatically start the next batch after a pre-set time which is set in the
adjacent window up to 99 sec.
Lead Guide Open Before Stripping – When this box is checked the the outfeed guide will move forward
to allow the strip slug to drop. This should be used if the lead end strip length of the wire will enter the outfeed
guides but not the outfeed belts. For shorter strip lengths do not check this box because it does reduce the parts
per hour.
Strip Adjust – This is to calibrate the strip end so that you measure the same strip length as you program.
This is a compensation value so if you program a 10mm lead strip and it measures to be 11mm, you would enter
a -1.0mm for the lead strip adjust.
Description – This is for any notes that are related to the part. This text is not displayed or used in any
other location.
To Next Page
Loading...
