Artos CS-326 - Wm6; Continuous Stamp (Even Step); 2-End Stamp

74
WM6
With the WM 6 two type sets are used. This allows for same or unique making on either end of the
wire as depicted at the bottom of he window. The wire will be cut between the marks. Using a single
type holder or two holders that make up one message makes the Wm 6 useable in any of the Hot
Stamp configurations.
A single type holder maker cannot practically be used as a WM 6 type marker.
ContinuousStamp(EvenStep)
This is a continuous repeating mark spaced evenly along the wire. The example above would produce a
wire with marks every 6”.
2‐EndStamp
This allows you to use a single type-set marker to mark the same mark on both ends of the wire with
same or different spacing from the ends. The example above would space the marks 2’ from each end.