52
o None is no preprocess installed
o Inkjet is for an Imaje S8 ink jet marker
o Inkjet ā Imaje-9040M is for an Imaje 9040 M head ink jet marker
o Inkjet- Imaje-9040G is for an Imaje 9040 G head ink jet marker
o Inkjet ā CodeBox-3 is for a Domino Codebox 3 printer, this interface has limited
functionality and is not recommended for new installations.
o Hot stamp is a heat transfer type marker. Examples are WM6, KIP 20. For these
markers the moment the ready signal activates the wire can be pulled.
o Hot stamp with FB+75 is a heat transfer type marker. Examples are HS4140. The
difference between this and the Hot Stamp is that the machine waits for 75mS after
receiving the ready signal, before it starts pulling wire. This is for markers that are
basically using the stamping cylinder power as the ready signal.
o Wraptor is for the Brady Wraptor labeler. This process will trip the Wraptor to put
the label on. The user must select the label to be printed on the Wraptor before
running the CS326 does not transmit the label data.
o Slitter is for axial slitting of the wire
o Steady on / other turns on a preprocess and looks for a ready feedback. This would be
for use with a Clinton HF-15A Spark tester or an ultraviolet curing light.
o Continuous II is a heat transfer type marker. Examples are WM6, KIP 20. This
process is the same as the Hot Stamp except that it is a special mode of printing that
hot stamp does not have. This is just for continuous printing and you can program a
distance from the end of the wire to the first mark and you can program the distance
between the marks.
To Next Page
Loading...
