96
Of course variations on the use of this mode are possible. However keep in mind the basic rules stated
earlier. For one thing the spacing and size of the windows do not have to be so uniform as in the
example. Anything within the normal part programming parameter limits may be used.
Note also that in order to get perforations and slitting to line up properly it is necessary to have the wire
feed properly calibrated for the wire being used and to place an appropriate value in the pre-process
distance (@___).
Part 1 definition:
275 length
35 lead outer strip length
6 lead inner strip length
37.5 tail outer strip length
6 tail inner strip length
2.8 large diameter (really from wire table)
1.3 small diameter
slitter - ON pre-process type
0 O1
35 L1
237.5 O2
37.5 L2
Part 2 definition:
225 length
37.5 lead outer strip length
6 lead inner strip length
37.5 tail outer strip length
6 tail inner strip length
2.8 large diameter (really from wire table)
1.3 small diameter
slitter - ON
0 O1
37.5 L1
187.5 O2
37.5 L2
Part 3 definition:
225 length
37.5 lead outer strip length
6 lead inner strip length
37.5 tail outer strip length
To Next Page
Loading...
