TD 92644EN
User Manual
Ascom d81 DECT Handset
14 Maintenance
99
18 June 2018 / Ver. K
1 On the new handset, press and hold
Note: Do not release until you are instructed to do so.
2 Put the new handset in the charger.
3 When the text "Start phone replacement?" is displayed, release .
Press "Yes" (left soft key).
The text "Follow the instructions. Each step can take several minutes." appears in
the display. Press "OK" (left soft key).
4, 5 When the text "Please insert old phone in charger" is displayed, replace the new
handset with the old handset. The handset can either be switched on or off.
Note: If the CR3 Charging Rack is used, the left charging slot must be used for
both handsets.
The handset is restarted and after a few seconds, the text "Saving settings. Do
not remove phone from charger" appears. The charger LED changes to slow
orange flashing. It may take several minutes.
IMPORTANT: If the old handset cannot communicate with the charger, put the
new handset in the charger to restore its settings (that is, the handset’s IPDI). If
this step is not performed, the new handset must be sent for service. The old
handset’s settings might be transfered to the new handset by using PDM/Device
Manager. See the handset’s Configuration Manual.
6, 7 When the text "Please insert new phone in charger" is displayed, replace the old
handset with the new handset. The text "Restoring settings" is displayed.
IMPORTANT: Do not remove the handset while the text "Restoring settings" is
displayed
011
New
1
23 56
4, 8 7
New
New Old
To Next Page
Loading...
Need help?
General
