After removing any dust, firmly and completely insert the power cable plug into the outlet.
If dust stays on the power cable plug or the plug is inserted incompletely, heat generation
and fire may result.
When removing the power cable plug, be sure to hold on the plug body (not the cable).
The power cable may be damaged, resulting in an electric shock or fire due to short
circuit.
Do not use the product with the power cable loosely connected. Fire or electric shock
may result.
Periodically remove the power cable plug, and wipe off dust and dirt which accumulate on
its periphery and the outlet. If the power cable plug is kept connected in a humid place or
a place greatly exposed to oily smoke, for an extended period of time, dust which has
accumulated on the periphery of the plug absorbs humid and fire may occur.
The grounding wire must not be connected to gas pipes, water pipes, lightning conductor
rods, or the grounding wires for phones. Inappropriate grounding may cause electric
shock.
Connecting the grounding cable to a gas pipe is very dangerous. Be sure that such
connections are never made.
Do not touch the electric components including the power cable plug with wet hands.
Also, do not perform switch operations with wet hands. Electric shock may result.
Never use explosive or flammable substances and any materials which contain such
substances. Explosion or fire may occur.
When supplying this product with CO
2
or N
2
gas, check the type of the gas, and confirm
that pipe connections have been made properly and no gas leakage occurs. Also, be sure
to use the specified level of pressure. If the specified level of gas pressure is not followed,
explosion, fire, or gas leakage can occur, resulting in gas poisoning or the absence of
oxygen.
Be sure that the pressure supplied for this product does not exceed 0.05 MPa ±0.01 MPa.
If the gas pressure is too high, a problem such as disconnection of the pipe in the product
can occur, resulting in gas poisoning or the absence of oxygen.
When installing and using the product, perform ventilation. Installing and using in a small
sealed room can result in gas poisoning or the absence of oxygen. Also, after opening the
door, be careful not to inhale air remaining in the equipment.
Do not put metal objects such as pins, wire or any other objects into the vent hole or
clearance of the product. Electric shock or personal injury may result.
To Next Page
Loading...
Need help?
General
