Chapter 1 – Installation of the instrument
UM-22100H-U User manual ATEQ D520 Page 19/122
2.2.1. 5) J3 connector (Inputs/Outputs All or Nothing)
programmable input
Input 7 can be programmed in the CONFIGURATION/INPUT 7 menu.
The functions programmable on this input are all the special cycles, which are :
9 Program selection,
9 Regulator adjustment request,
9 Infinite fill request,
9 Piezo reset request,
9 Manual differential reset request,
9 Calibration learning request,
9 Calibration check request,
9 ATR learning request,
9 Reference adjustment request.
Some possibilities only appear if the function is used.
To Next Page
Loading...
