SIP User's Manual 282 Document #: LTRT-68806
Mediant 2000 & TP-1610 & TP-260/UNI
Table 6-2: System Parameters
ini File Field Name
Web Parameter Name
Valid Range and Description
CDRReportLevel
For a description of this parameter, refer to 'General Parameters' on
page 103.
CDRSyslogServerIP
For a description of this parameter, refer to 'General Parameters' on
page 103.
HeartBeatDestIP
Destination IP address (in dotted format notation) to which the gateway
sends proprietary UDP 'ping' packets.
The default IP address is 0.0.0.0.
HeartBeatDestPort
Destination UDP port to which the heartbeat packets are sent.
The range is 0 to 64000. The default is 0.
HeartBeatIntervalmsec
Delay (in msec) between consecutive heartbeat packets.
[10] = 100000.
[-1] = disabled (default).
EnableRAI
[0] = Disable RAI (Resource Available Indication) service (default).
[1] = Enable RAI service.
If RAI is enabled, an SNMP 'acBoardCallResourcesAlarm' Alarm Trap is
sent if gateway's busy endpoints exceed a predefined (configurable)
threshold.
RAIHighThreshold
High Threshold (in percentage) that defines the gateway's busy
endpoints.
The range is 0 to 100. The default value is 90%.
When the percentage of the gateway's busy endpoints exceeds the
value configured in High Threshold, the gateway sends an SNMP
'acBoardCallResourcesAlarm' Alarm Trap with a 'major' Alarm Status.
Note: The percentage of busy endpoints is calculated by dividing the
number of busy endpoints by the total number of “enabled” endpoints
(trunks are physically connected and synchronized with no alarms and
endpoints are defined in the Trunk Group table).
RAILowThreshold
Low Threshold (in percentage) that defines the gateway's busy
endpoints.
The range is 0 to 100. The default value is 90%.
When the percentage of the gateway's busy endpoints falls below the
value defined in Low Threshold, the gateway sends an SNMP
'acBoardCallResourcesAlarm' Alarm Trap with a 'cleared' Alarm Status.
RAILoopTime
Time interval (in seconds) that the gateway checks for resource
availability.
The default is 10 seconds.
Disconnect Supervision Parameters
DisconnectOnBrokenCon
nection
For a description of this parameter, refer to 'General Parameters' on
page 103.
BrokenConnectionEvent
Timeout
For a description of this parameter, refer to 'General Parameters' on
page 103.
EnableSilenceDisconnect
For a description of this parameter, refer to 'General Parameters' on
page 103.
To Next Page
Loading...
Need help?
General