Version 5.2 283 September 2007
SIP User's Manual 6. ini File Configuration
Table 6-2: System Parameters
ini File Field Name
Web Parameter Name
Valid Range and Description
FarEndDisconnectSilenc
ePeriod
For a description of this parameter, refer to 'General Parameters' on
page 103.
FarEndDisconnectSilenc
eMethod
For a description of this parameter, refer to 'General Parameters' on
page 103.
FarEndDisconnectSilenc
eThreshold
Threshold of the packet count (in percents), below which is considered
silence by the gateway.
The valid range is 1 to 100. The default is 8%.
Note: Applicable only if silence is detected according to packet count
(FarEndDisconnectSilenceMethod = 1).
Automatic Update Parameters
CmpFileURL
Specifies the name of the cmp file and the location of the server (IP
address or FQDN) from which the gateway loads a new cmp file and
updates itself. The cmp file can be loaded using: HTTP, HTTPS, FTP,
FTPS or NFS.
For example: http://192.168.0.1/filename
Notes:
When this parameter is set in the ini file, the gateway always loads
the cmp file after it is reset.
The cmp file is validated before it's burned to flash. The checksum of
the cmp file is also compared to the previously-burnt checksum to
avoid unnecessary resets.
The maximum length of the URL address is 99 characters.
IniFileURL
Specifies the name of the ini file and the location of the server (IP
address or FQDN) from which the gateway loads the ini file. The ini file
can be loaded using: HTTP, HTTPS, FTP, FTPS or NFS.
For example:
http://192.168.0.1/filename
http://192.8.77.13/config<MAC>
https://<username>:<password>@<IP address>/<file name>
Notes:
When using HTTP or HTTPS, the date and time of the ini file are
validated. Only more recently-dated ini files are loaded.
The optional string '<MAC>' is replaced with the gateway's MAC
address. Therefore, the gateway requests an ini file name that
contains its MAC address. This option enables loading different
configurations for specific gateways.
The maximum length of the URL address is 99 characters.
PrtFileURL
Specifies the name of the Prerecorded Tones file and the location of the
server (IP address or FQDN) from which it is loaded.
For example: http://server_name/file, https://server_name/file.
Note: The maximum length of the URL address is 99 characters.
CptFileURL
Specifies the name of the CPT file and the location of the server (IP
address or FQDN) from which it is loaded.
For example: http://server_name/file, https://server_name/file.
Note: The maximum length of the URL address is 99 characters.
To Next Page
Loading...