AUMA ACVExC 01.2 Series User Manual

305.3.4. Assignment of analogue output 2
305.3.5. Signal range of analogue output 2
305.3.6. Adjustment of analogue output 2
326. Operation ...............................................................................................................................
326.1. Operation mode Off
326.2. Operation mode Local
326.2.1. Push-to-run operation or self-retaining Local
336.3. Operation mode Remote
336.3.1. Push-to-run operation or self-retaining Remote
346.4. Operation mode EMERGENCY
346.5. Operation mode EMERGENCY stop
356.6. Operation mode Disabled
356.7. Operation mode Service
367. Basic settings for commissioning........................................................................................
367.1. Type of seating for end positions
367.1.1. Type of seating: set
377.2. Torque switching
387.2.1. Torque switching: set
397.3. Limit switching
397.3.1. Limit switching: set
417.4. Date and time
417.5. Display formats
417.5.1. Date format
417.5.2. Time format
417.5.3. Number format
427.5.4. Torque unit
427.5.5. Temperature unit
427.5.6. Position units
437.5.7. Process factor units
437.5.8. Analogue working value units (AIN)
447.5.9. Analogue signal output units (AIN)
447.6. Contrast
458. Application functions.............................................................................................................
458.1. Speed functions
458.1.1. Speed source for local operation and remote operation
468.1.2. Speed for constant (internal) speed setpoint: set
478.1.3. Speed range for analogue input: set
478.1.4. Speed reduction before reaching end positions OPEN/CLOSED (soft stop in end posi-
tions)
488.2. Intermediate positions (pivot points)
488.2.1. Intermediate positions (pivot points): define
488.2.2. Signal behaviour of intermediate positions: set
498.2.3. Hysteresis for intermediate positions: set
508.3. Operation profile (operation behaviour) for intermediate positions
508.3.1. Operation profile: activate
508.3.2. Operation profile for intermediate positions (pivot points): set
518.3.3. Off times for intermediate positions (pivot points): set
518.4. Two-wire control
528.5. Positioner (operation mode Remote SETPOINT)
3
Actuator controls
ACV 01.2/ACVExC 01.2 Table of contents

AUMA ACVExC 01.2 Series Specifications

General

Brand	AUMA
Model	ACVExC 01.2 Series
Category	Controller
Language	English