AUMA ACVExC 01.2 Series User Manual

528.5.1. Positioner: activate
538.5.2. Adaptive behaviour: switch on or off
538.5.3. Overrun (inner dead band): set manually
548.5.4. Max. error variable (outer dead band): set manually
548.5.5. Dead time: set
548.5.6. Hysteresis for positioner: set
548.5.7. Closing fully/opening fully (end position tolerance for setpoint)
558.5.8. Setting range: limit
568.5.9. Speed reduction before reaching setpoint position
568.5.10. Change-over between OPEN - CLOSE control and setpoint control
578.5.11. Input of setpoint position
578.5.12. Input range of setpoint position
578.5.13. Split Range operation
588.6. Process controller
598.6.1. Process controller activation
598.6.2. Process controller: set modulating behaviour
608.6.3. Setpoint source (input for process setpoint)
618.6.4. Behaviour on loss of process setpoint
618.6.5. Inverse operation
618.6.6. Internal process setpoint
628.6.7. Setting procedure
628.6.8. Proportional amplification Kp: set
628.6.9. Reset time Ti: set
628.6.10. Rate time Td: set
638.6.11. Actual value source (input for actual process value)
638.6.12. Speed source for actual process value
638.7. Stepping mode
648.7.1. Stepping mode: activate
648.7.2. Operation mode for stepping mode
658.7.3. Start and end of stepping mode
658.7.4. On times and off times
658.8. By-pass function
678.8.1. Bypass function: activate
678.8.2. By-pass application: configure
678.9. Automatic deblocking
688.9.1. Automatic deblocking function: activate
688.9.2. Operation time for operation in opposite direction: set
688.9.3. Number of deblocking attempts: set
698.9.4. Tolerance range: set
698.10. Synchronous link
708.10.1. Synchronous link function: activate
708.10.2. Role (master actuator/slave actuator): define
718.10.3. Deviation: set
718.11. Heater system and heaters
718.11.1. Heater system within the actuator controls
718.11.2. Heater on control unit (actuator)
728.11.3. Motor heater
739. Failure functions....................................................................................................................
739.1. Reversing prevention time
739.2. Failure behaviour on loss of signal
4
Actuator controls
Table of contents ACV 01.2/ACVExC 01.2

AUMA ACVExC 01.2 Series Specifications

General

Brand	AUMA
Model	ACVExC 01.2 Series
Category	Controller
Language	English