113
When the operation is successfully completed, a “Completed
successfully” message will display on the screen, press OK to exit.
9.2.3 Parking Brake: Workshop Mode
This service is used to activate and deactivate the installation position for the
Automatic Hold brake. In this mode the parking brake is moved into the
opened position and temporarily deactivated (personal protection).
The installation position must be activated for the following repairs:
⚫ Replacement of brake pads.
⚫ Replacement of a brake caliper.
⚫ Replacement of an actuator.
Select Parking Brake: Workshop Mode and follow the on-screen
instructions to perform a series of operations to initiate the brake pad after
replacement.
When the operation is successfully completed, a “Completed successfully”
message will appear on the screen. Press ESC to exit.
To Next Page
Loading...
