64
6.2 Test Preparation
6.2.1 Inspecting the Battery
Before starting a test, inspect the battery for:
⚫ Cracking, buckling or leaking (If you see any of these defects, replace
the battery.)
⚫ Corroded, loose or damaged cables and connections (Repair or replace
as needed.)
⚫ Corrosion on the battery terminals, and dirt or acid on the case top (Clean
the case and terminals using a wire brush and a mixture of water and
baking soda.)
6.2.2 Establishing Communication
➢ To connect BT506 with ITS600/ITS600 Pro
1. Turn on both BT506 and ITS600/ITS600 Pro.
2. Tap the Settings application on the MaxiTPMS Job Menu of the
ITS600/ITS600 Pro, and select VCI Manager.
3. Tap Scan at the upper right corner of the tablet’s screen.
4. The device name may display as Maxi suffixed with a serial number.
Select the appropriate device for pairing.
5. When paired successfully, the connection status displays the
device name with the message Paired.
6. Once paired, the VCI button on the upper right corner of the screen
will display a green check and the Connection LED on the BT506
illuminates blue. This signifies that the tablet is connected to the
BT506, and is ready to for use.
To Next Page
Loading...
