59
5 TPMS Retrofit
Retrofit is needed to be performed if your vehicle is not installed with TPMS
system by default. Tap on the TPMS Retrofit application button on the
MaxiTPMS Job Menu to access the function.
5.1 Retrofit
This function is used to install TPMS system in vehicles. Tapping the TPMS
Retrofit application icon opens the vehicle identification screen. See Vehicle
Identification on page 19 for additional information.
Prior to use the function, ensure the ignition light is in ON position with the
V200 device successfully connected to the vehicle and the tablet.
➢ To perform retrofit function
1. Tap the TPMS Retrofit icon.
2. Select the manufacturer button of the test vehicle, followed by the
vehicle model and year.
3. Tap OK at the bottom of the screen to confirm information of the
tested vehicle. The Retrofit screen opens.
4. Simply follow the operations guide displayed on the screen, which
will guide you to choose the corresponding buttons during each
procedure, including the Back-up, Retrofit, and Restore button.
The Retrofit function screen has the same lay out with that of the TPMS
screen. After the retrofit function is finished, tap on the other tabs to perform
optional functions.
To Next Page
Loading...
