52
4.8.2 Check mode
There are four check modes provided. Below are the detailed descriptions.
4.8.2.1 All tread check
The All tread check function assists to examine your tire wear in three
separate areas: outer, center, and inner for a comprehensive analysis.
4.8.2.2 Single check
The single check function allows for measuring tread depth on each tire
of the test vehicle. Unlike All tread check, single check only measures
one location on each tire for results.
4.8.2.3 Quick check
The function combines measuring tread depth together with brake disc
wear to make it easy for technicians.
4.8.2.4 Brake disc check
The brake disc check function checks for brake disc wear and provides
wear analysis. Similar to single check that targets tire depth, this check
mode focus on brake disc measurements only.
➢ To pair the tablet with the TBE device via Wi-Fi direct mode
1. On the TBE device, go to Settings > Network connection > Wi-
Fi direct, and swipe the Wi-Fi direct toggle to turn it on.
2. On the tablet, go to Settings > TBE Manager to open the TBE
Manager screen. Or, open the TPMS application, on the Wear
detection screen, click the TBE icon to access the TBE Manager
screen for connection.
3. Tap Scan at the upper right corner of the tablet's screen. The tablet
will automatically search for available TBE devices.
4. The name of the device will appear. Select the device for
connection, and tap the device name to establish a communication
link.
5. After the connection is established, open the Tire Tread application
on the TBE device and start measuring.
To Next Page
Loading...
