33
⚫ In case of Bluetooth connection, check if the network is configured
correctly, or if the right MaxiVCI V200 has been paired up with the
tablet.
If communication is lost during diagnosis, ensure there is no
nearby object that might cause signal interruption.
Stand closer to the MaxiVCI V200 to o Bluetooth ain a stronger
signal, and a faster communication speed.
⚫ When using USB connection, check the cable connection between
the tablet and the MaxiVCI V200.
⚫ Check the Power LED on the MaxiVCI V200. A blinking red light
indicates there is a hardware problem with the MaxiVCI V200.
Contact technical support for assistance.
2. A message will display if the MaxiVCI V200 is unable to establish a
communication link. The followings are the possible causes:
⚫ The MaxiVCI V200 is unable to establish a communication link with
the vehicle.
⚫ The system selected for testing is not equipped on the vehicle.
⚫ There is a loose connection.
⚫ There is a blown vehicle fuse.
⚫ There is a wiring fault of the vehicle or the adapter.
⚫ There is a circuit fault in the adapter.
⚫ Incorrect vehicle identification was entered.
4.4.2 Diagnosis Operations
Tap Diagnostics, the tablet will automatically communicate with the vehicle.
To Next Page
Loading...
