48
4.7 Retrofit
Refer to TPMS Retrofit on page 59 for details.
4.8 Wear Detection
The wear detection is for detecting wear status of tire tread and/or brake disc,
which contains four types of checks, including All tread check, Quick check,
Single check, and Brake disc check operations, and allows for adding tire
tread depth & brake disc wear measurement data into TPMS test report for
comprehensive analysis.
The wear detection function is designed to be performed by using the TBE200
device (hereafter referred to as TBE device). Once paired, you can initiate
check sessions through the TBE device, which will take full control to perform
measurements with the data detected automatically transferred to the paired
tablet.
There are two ways of switching to a different check mode via the TBE device:
A. All tread check/Single check – On the TBE device, tap the Tire Tread
icon on the Main Job screen, a prompt will display, notifying the current
check mode. Tap Cancel to stay in the current mode, or tap Switch to
perform the other check mode. You can also switch between All tread
check and Single check in the Check Settings.
B. Quick check/Brake disc check – On the TBE device, simply tap the
Quick Check or Brake Disc icon on the Main Job screen to execute the
checking procedure.
To Next Page
Loading...
