120
Calibration must always be carried out after the following operations:
⚫ Steering wheel replacement
⚫ Steering angle sensor replacement
⚫ Any maintenance that involves opening the connector hub from the
steering angle sensor to the column
⚫ Any maintenance or repair work on the steering linkage, steering gear or
other related mechanism
⚫ Wheel alignment or wheel track adjustment
⚫ Accident repairs where damage to the steering angle sensor or assembly,
or any part of the steering system may have occurred
NOTE
1. Autel accepts no responsibility for any accident or injury arising from
servicing the SAS system. When interpreting DTCs retrieved from the
vehicle, always follow the manufacturer’s recommendation for repair.
2. All software screens shown in this manual are examples, actual test
screens may vary by test vehicle. Pay attention to the menu titles and
onscreen instructions to make correct option selections.
3. Before starting procedure, make sure vehicle has ESC. Look for button
on dash.
➢ To perform SAS service (Take Land Rover as an example)
1. Tap the Service application button on the MaxiTPMS Job Menu.
2. Tap SAS button. The vehicle manufacturer selection screen displays.
Tap VIN Scan or the vehicle manufacturer to acquire vehicle VIN
information and tap Yes to confirm. See Vehicle Identification on
page 83 for details.
3. Tap the desired service in the SAS function list, the list may vary by
test vehicle.
To Next Page
Loading...
