Note:
Perform the following steps to ensure that IP Routing has been enabled globally on the
ERS.
24. Navigate to the IP Folder.
25. Select IP.
26. Select the Globals tab.
27. Select the forwarding radio button.
28. Click apply.
29. From the VLANs tab, double-Click on the ports assigned to VLAN 1 and change to ports 1 –
6 .
30. Click OK.
31. Click Apply.
32. Click Refresh.
33. Repeat steps 22 through 25 to assign switch ports to the remaining VLANs as follows :
VLAN 2 — Ports 7 – 12, V LAN 3 — Ports 13 – 18, and VLAN 4 — Ports 19 – 24.
ERS 3500 hardware features and VLAN configuration procedures
160 Getting Started with Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com
To Next Page
Loading...
