Avaya 3500 series - Page 70

Sync interval: 24 hours
Last sync source: 0.0.0.0
Primary server sync failures: 0
Secondary server sync failures: 0
Last sync time: Not Set
Next sync time: Not Set
Current time: Not Set
Enabling or disabling SNTP
Enable or disable Simple Network Time Protocol . The default value for SNTP is Disabled.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command (without the optional [no] parameter
to enable SNTP:
[no] sntp enable
Variable definitions
The following table describes the parameters for the sntp enable command.
Variable
Value
no Disables SNTP
Setting SNTP server primary secondary address
Set or clear the IP address for the primary or secondary NTP server.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
[no] sntp server <primary|secondary> address <A.B.C.D>
Variable definitions
The following table describes the parameters for the sntp server <primary|secondary>
address command.
Variable
Value
<A.B.C.D> Enter the IP address of the primary or secondary
NTP server in the format XXX.XXX.XXX.XXX.
Table continues…
Configuring the switch using ACLI
70 Getting Started with Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com