Avaya 3500 series - Page 71

Variable Value
DEFAULT: 0.0.0.0.
no Clears the NTP server IP addresses
<primary|secondary> Enter the NTP server you want to set or clear:
• primary — the IP address for the primary NTP
server
• secondary — the IP address for the secondary
NTP server
Forcing a Manual Synchronization with NTP Server
Force a manual synchronization with the NTP Server. This procedure is useful if the recurring
synchronization is long, and you want to correct or test the operation immediately, rather than
waiting for, or changing the reoccurrence period.
Before you begin
You must enable SNTP before this procedure can be performed.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
sntp sync-now
Setting up recurring synchronization
You can specify recurring synchronization with the NTP server in hours, relative to the initial
synchronization.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
sntp sync-interval <0–168>
Variable definitions
The following table describes the parameters for the sntp sync-interval command.
Configuring the switch using ACLI
July 2015 Getting Started with Avaya ERS 3500 Series 71
Comments on this document? infodev@avaya.com