Avaya 3500 series - Page 75

Variable Value
recurring starts, and the second specifies when the
recurring stops.
<hh:mm> Specifies the time in hours and minutes in military
format (24–hr). The first occurrence specifies when
the recurring starts, and the second specifies when
the recurring stops.
<1–1440> Specifies the number of minutes to add or subtract
during summer-time recurring.
Displaying the local time zone settings
Display the settings for the local time zone.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
show clock time-zone
Example
The following figure provides a sample of the output of the show clock time-zone command.
switch(config)#show clock time-zone
Time zone offset from UTC is 00:00
Displaying the daylight savings time settings
Display the daylight savings time settings.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
show clock summer-time
Example
The following figure provides a sample of the output of the show clock summer-time
command.
switch(config)#show clock summer-time
Summer time recurring is set to:
start: on Tuesday in the 1st week of June at 12:01
end: on Saturday in the 3rd week of September at 23:59
Configuring the switch using ACLI
July 2015 Getting Started with Avaya ERS 3500 Series 75
Comments on this document? infodev@avaya.com