Variable Value
Important:
<day> <month> parameters can also be
entered in order: <month> <day>.
offset Number of minutes to add during summer time
RANGE: —840 to 840
no Disables the daylight savings time feature
Specifying summer-time recurring dates
Specify the dates that recur during the summer-time clock every year. This procedure provides
flexibility for countries where the Daylight Savings Time is different than North America.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
clock summer-time recurring <1–5> <DAY> <MONTH> hh:mm> <1–5> <DAY>
<MONTH> <hh:mm> <1–1440>
Example
The following figure provides a sample of the output of the clock summer-time recurring
command.
switch(config)#clock summer-time recurring 1 tues Jun 12:01 3 sat Sep 23:57 1
Summer time recurring is set to:
start: 1st week of June on Tuesday at 12:01
end: 3rd week of September on Saturday at 23:57
Offset: 60 minutes.
Variable definitions
The following table describes the parameters for the summer-time recurring command.
Variable
Value
<1–5> Specifies the week of the month. The first
occurrence specifies when the recurring starts, and
the second specifies when the recurring stops.
<DAY> Specifies the day of the week as the first 3 letters of
the name. The first occurrence specifies when the
recurring starts, and the second specifies when the
recurring stops.
<MONTH> Specifies the Month using the first 3 letters of the
name. The first occurrence specifies when the
Table continues…
Configuring the switch using ACLI
74 Getting Started with Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com
To Next Page
Loading...
