Variable Value
Important:
You must ensure that SNTP is enabled before
you can enable AES efficiency mode.
Important:
You must disable AES globally before you can
modify AES efficiency mode.
Important:
When enabled, AES efficiency mode overrides
custom AES scheduling and PoE power saving
mode. You will be prompted to confirm that you
want to enable AES efficiency mode before
proceeding.
enable Enables AES globally.
[no] Disables AES efficiency mode, POE power saving,
or AES globally.
poe-power-saving Enables POE power saving.
Important:
You must disable AES globally before you can
modify POE power saving.
Configuring port-based AES using ACLI
Use the following procedure to enable or disable energy saving for the accessed port, an alternate
individual port, or a range of ports.
Before you begin
• Disable AES globally.
Procedure
1. Enter Interface Configuration mode:
enable
configure terminal
interface GigabitEthernet
2. Configure port-based AES.
[default] [no] energy-saver <enable> [port <portlist> enable]
Variable definitions
The following table defines optional parameters that you can enter with the [no] [default]
energy-saver <enable> [port <portlist> enable] command.
Configuring the switch using ACLI
July 2015 Getting Started with Avaya ERS 3500 Series 85
Comments on this document? infodev@avaya.com
To Next Page
Loading...
