Postmigration administration
110 Migrating to the Avaya S8700 or S8710 Media Server
June 2004
Figure 21: Connecting directly to the IPSI
NOTE:
Make sure you have the password before proceeding.
1 Connect the services laptop computer to the top port on the IPSI circuit pack faceplate.
2 From the services laptop Start Menu, click Start > Run to open the Run dialog box.
3 Type command and press Enter to open a MS-DOS Command Line window.
4 Type arp -d 192.11.13.6 and press Enter to clear the ARP cache in the laptop. This command
responds with one of the following:
• The command line prompt when the cache has been cleared.
• The phrase: The specified entry was not found. This is returned when the specified IP
address does not currently contain an entry in the ARP cache.
5 Type telnet 192.11.13.6 and press Enter to open the Telnet window and connect to the IPSI
Prompt = [IPSI]:
NOTE:
While connected to the IPSI, type help or ? to obtain online help. Most commands have
two or three letter abbreviations.
Figure notes
1 Services laptop
2 PCMCIA Network Interface Card (NIC)
3 NIC adapter cable (if necessary)
4 CAT5 crossover cable to IPSI
cadlipsi KLC 031502
1
2
CLK
S
E
R
V
I
C
E
N
E
T
W
O
R
K
3
4
To Next Page
Loading...
