About This Documentation
Conventions
16 Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway
December 2003
• Connecting UPS Ethernet cables to an Ethernet switch on page 46
• Configuring the SNMP modules in the uninterruptible power supplies on page 47
• Configuring the SNMP subagent in the Avaya Ethernet switch (if used) on page 51
• Customizing the media server on page 53
You next install the media gateways, using sections in Installing the media gateways on page 58 as
appropriate for the system you are installing.
Perform tasks related to the Main Distribution Frame in the following sections as appropriate:
• Installing the main distribution frame on page 134
• Connecting the media gateway to the main distribution frame on page 149
• Connecting the main distribution frame to stations and the public switched telephone network on
page 155
Connect the system to the customer’s network using information in Connecting to the IP server interfaces
on page 181.
Connect the necessary telephone, trunking, and peripheral equipment using the information in Installing
and wiring telephones and trunks on page 193 and Installing and wiring telephone power supplies on
page 228.
Complete the installation using information in the following sections:
• Completing the installation administration on page 246
• Accessing the media server on page 255
• Testing the complete configuration on page 263
If problems occur during the installation, use Troubleshooting an installation
on page 287 to try to resolve
them.
Conventions
This section describes the conventions that we use in this book.
General
We show commands and screens from the newest Communication Manager and refer to the most current
documentation.
Physical dimensions
All physical dimensions are in English units followed by metric units in parentheses. Wire gauge
measurements are in AWG followed by the diameter in millimeters in parentheses.
To Next Page
Loading...
