Avaya S8700 - Connecting Trunk Pairs to Media Gateway Using Jumper Wires to Establish 3-Pair Modularity

Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway 179
December 2003
Connecting trunk pairs to media gateway
using jumper wires to establish 3-pair
modularity
Figure 71, 3-pair modularity for trunk pairs for 1-pair trunks, on page 179 and Figure 72, 3-pair
modularity for trunk pairs for 3-pair Tie trunks, on page 180 show trunk pairs connected to the media
gateway with jumper wires to establish 3-pair modularity.
To connect the trunk pairs to the purple field:
1 Connect B25A cables between the network interface and the sneak fuse panels. See Figure 71, 3-
pair modularity for trunk pairs for 1-pair trunks, on page 179.
2 Connect A25D/B25A cables from the sneak fuse panels to the 110-type terminal block-type
connecting block connectors in the green field.
3 Connect 1-pair patch cords/jumper wires from each 110-type terminal block row in the green field
to the 110-type terminal block rows in the purple field for 1-pair central office (CO) trunks or in
Figure 72, 3-pair modularity for trunk pairs for 3-pair Tie trunks,
on page 180 for 3-pair tie trunks.
Figure 71: 3-pair modularity for trunk pairs for 1-pair trunks
Figure notes
1 Green Field
2 1-Pair Jumpers
3 Pairs
4 Purple Field
12345678
1 4 7 1013161922
1 4 7 1013161922
1 4 7 10 13 16 19 22
9 10111213141516 1718192021222324
r7
58
42
5b
MMR
03
14
96