Avaya S8700 - Customizing the Media Server; Starting Terminal Emulation; Inputing Translations

Customizing the media server
Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway 53
December 2003
Customizing the media server
For SAT commands, use a Native Configuration Manager, such as Avaya Terminal Emulator or
HyperTerminal. You also can use Avaya Site Administration, part of the Avaya Integrated Management
suite, which you can purchase from Avaya.
NOTE:
You must use Release 1.11 or a later version of Avaya Site Administration, to be able to
administer new features in Release 2.0 of Avaya Communication Manager.
Perform these tasks to customize the media server:
• Starting terminal emulation on page 53
• Inputing translations on page 53
• Resetting media server on page 54
• Adding media gateways on page 54
• Administering the IP server interface on page 54
• Saving translations on page 57
Starting terminal emulation
NOTE:
Avaya Terminal Emulation and HyperTerminal are supported terminal emulation
applications.
1 On the services laptop, open a VT-100 terminal emulation session.
2 Administer the terminal emulation port settings:
• 9600 baud
• No parity
• 8 data bits
• 1 stop bit
• No flow control
3 Log into the media server as craft.
Inputing translations
Contact the installation personnel responsible for translation input to download translations.
• Type save translations and press Enter to save the translations to the hard drive.
If the translations are not ready, you may continue with the process, entering minimal translations to
verify connectivity to the port networks.