Completing the installation administration
246 Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway
December 2003
Completing the installation administration
This section covers the following tasks:
• Verifying translations on page 246
• Setting daylight savings time rules on page 246
• Setting locations (if necessary) on page 247
• Verifying date and time on page 248
• Viewing alarms on page 248
• Enabling and disabling Ethernet switch ports on page 249
• Backing up the media server to PCMCIA flashcard on page 251
• Telneting to media server on page 253
• Enabling alarms to INADS via modem on page 253
• Enabling alarms to INADS via SNMP on page 253
• Enabling alarms to INADS on second server on page 254
• Registering the system on page 254
Verifying translations
1 Type list configuration all and press Enter to view all the administered circuit packs in the
system.
2 Type list ipsi and press Enter to verify the location of the IPSI circuit packs.
3 Check the administration status on the following items:
• list station
• list trunk-group
• list hunt-group
NOTE:
Even though you set the date, time, and time zone through the Web interface on the media
server, you also must set the daylight savings time rules and locations and verify the date
and time through SAT commands.
Setting daylight savings time rules
You can set up to 15 customized daylight savings time rules. If you have media gateways in several
different time zones, you can set up rules for them on a per-location basis. A daylight savings time rule
specifies the exact time when you want to transition to and from daylight savings time. It also specifies
the increment at which to transition.
NOTE:
The default daylight savings rule is 0, meaning no daylight savings transition.
To Next Page
Loading...
