Connecting to the IP server interfaces
Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway 181
December 2003
Connecting to the IP server interfaces
NOTE:
The media gateways must be installed, connected to each other, and powered up.
This section covers the following tasks:
• Connecting to the internet protocol service interface circuit packs on page 181
• Programming the internet protocol service interface circuit packs on page 182
• Using DHCP addressing on page 182
• Using static addressing on page 183
• Verifying that IPSIs are translated on page 187
• Verifying connectivity to media server on page 187
• Upgrading IPSI firmware version (if necessary) on page 187
• Enabling IPSI duplication (high or critical reliability only) on page 187
• Enabling control of IPSIs on page 188
• Verifying license status on page 189
Connecting to the internet protocol service
interface circuit packs
NOTE:
Once the IPSIs are connected to the control network, they may alarm if the firmware is not
the most current. The alarm automatically goes away once the IPSI firmware is upgraded.
If duplex reliability, connect one end of the GREEN CAT5 straight-through cable to the IPSI adapter on
the back of media gateway in position A.
If high or critical reliability, in addition connect one end of the RED CAT5 straight-through cable to the
IPSI adapter on the back of media gateway in position B.
Dedicated control network: The other end is connected to the next available port on the Ethernet switch.
Nondedicated control network: The other end is connected to the next available port on the customer’s
network. If not already connected, connect it.
For a connectivity guide, see Getting Started with the Avaya S8700 Media Server with the Avaya G650
Media Gateway
To Next Page
Loading...
