Avaya S8700 - Installing the Software

Configuring the media server
36 Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway
December 2003
2 Type telnet and press Enter to open a Microsoft Telnet session.
3 Type display and press Enter to see the current settings. If message says
Sending only CR
then close the dialog box.
If message says
Sending both CR & LF
then continue with step 4.
4 Type unset crlf and press Enter.
5 Type display and press Enter to verify that the settings changed. The message should say
Sending only CR
6 Close the dialog box.
Installing the software
NOTE:
If after you open a Telnet session on the media server and you get a login prompt, you may
have a hard drive with software on it rather than a blank hard drive. If that is the case, go
to Remastering the hard drive
on page 41 then come back to this step.
NOTE:
Use a telnet session to access the information on the CD.
1 Type telnet 192.11.13.6 and press Enter to view the first screen.
NOTE:
To navigate on these screens, use the arrow keys to move to an option, then press the space
bar to select the option. Press Enter to submit the screen.