Avaya S8700 - Telneting to Media Server; Enabling Alarms to INADS Via Modem; Enabling Alarms to INADS Via SNMP

Completing the installation administration
Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway 253
December 2003
6 Click Backup now to back up all data to the PCMCIA flashcard.
Telneting to media server
1 Click Start > Run to open the Run dialog box
2 Type telnet 192.11.13.6 and press Enter.
3 Log in as craft or dadmin (if business partner).
Enabling alarms to INADS via modem
NOTE:
These steps must be done on both media servers.
1 Type almenable -d b and press Enter.
2 Type almenable and press Enter to verify that the alarms are enabled.
Enabling alarms to INADS via SNMP
NOTE:
Do these steps only if a Secure Service Gateway (SSG) is being installed. For further
information on the SSG device, see (Avaya personnel only): http://135.8.11.4/team-sra/
.
NOTE:
These steps must be done on both media servers.
1 Type almsnmpconf -d ipaddress -c communityname and press Enter, where ipaddress is the
trap receiver address for the SSG device and communityname is the community string name
required by the SSG device.
2 Type almsnmpconf and press Enter.
Verify that the correct information was entered.
3 At the prompt, type almenable -s y and press Enter.