Testing the complete configuration
Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway 279
December 2003
Figure 112: LEDs on Powerware 9125 UPS
After plugging in the UPS, all the LEDs flash briefly. After a self test, the Normal mode LED flashes,
indicating that the UPS is in Standby mode.
For more information on the LEDs, see the UPS user’s guide that comes with the Powerware 9125 UPS.
Telephone console LEDs
Telephones and attendant consoles have some alarm LEDs that must be checked out.
Attendant console LEDs
The console has two red LEDs, labeled “ALM” and “ACK”. The ALM LED lights steadily when there is
a major or minor alarm at the media server. The ACK LED lights steadily if the alarm has been
successfully reported to INADS. If the media server is unable to report the alarm to INADS, the LED
flashes; this signals the attendant to call INADS and report the alarm.
Figure notes
1 Normal mode indicator
2 Battery mode indicator
3 Bypass mode indicator
4 Test/Alarm reset button
5 Off button
6 On button
7 Bar graph indicators
8 Alarm indicators
1
2
3
4 5
6
7
8
ledlups KLC 030102
To Next Page
Loading...
