Accessing the media server
262 Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway
December 2003
Windows 2000 instructions
1 On your desktop right-click Network Neighborhood > Properties to display the Network dialog
box.
2 In the window, select the TCP/IP that corresponds to your Ethernet card.
3 Click Properties.
4 Select Specify an IP address:
• IP address: 192.11.13.5
• Subnet Mask: 255.255.255.252
5 Click OK, OK to accept the information and close the windows.
6 Reboot the computer to effect the changes.
Windows 2000/XP instructions
1 On your desktop (under Start for XP), right-click My Network Places > Properties to display the
Network and Dial-up Connections window.
Windows 2000 should have automatically detected the Ethernet card in your system and created a
LAN connection for you. More than one connection may appear.
2 Right-click on the correct Local Area Connection > Properties to display the Local Area
Connection Properties dialog box.
3 Select Internet Protocol (TCP/IP).
4 Click Properties to display the Internet Protocol (TCP/IP) Properties dialog box.
5 On the General tab, select Use the following IP address. Enter the following:
• IP address: 192.11.13.5
• Subnet mask: 255.255.255.252
Make a note of any IP addresses or other entries that you have to clear. You may need to restore
them later to connect to another network.
6 Select Use the following DNS server addresses. The entries for Preferred DNS server and
Alternate DNS server should both be blank.
7 Click Advanced at the bottom of the dialog box to display the Advanced TCP/IP Settings dialog
box.
8 Click the DNS tab. Make sure no DNS server is administered (the address field should be blank).
To Next Page
Loading...
