Avaya S8700 - Testing Expansion Interface Exchange, if Used, for each Port Network

Testing the complete configuration
Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway 269
December 2003
Figure 107: Sample test results for TDM bus port network 1
Testing expansion interface exchange, if
used, for each port network
If the configuration is critical reliability, test the expansion interface exchange for each PN.
1 Type status port-network number <1-64> and press Enter.
This displays the standby expansion link. See Figure 108, Sample of port network status before
expansion link is set, on page 270.
2 Type set expansion-link UUCSS, where UUCSS is one of the cabinet, and port locations of the
standby expansion link, and press Enter.
3 Verify the bottom of the screen displays:
Command successfully completed
4 Type status port-network number <1-64> and press Enter.
A screen similar to Figure 109, Sample of port network status after expansion link is set,
on page
270 displays.
5 Verify that the MODEs of the expansion links have changed.
6 If any problems are indicated, check the TDM cables and the inter-cabinet cables (ICC) in the
associated port network.
test tdm port-network 1
TEST RESULTS
Port Maintenance Name Alt. Name Test No. Result Error Code
PN 01A TDM-BUS 294 PASS
PN 01A TDM-BUS 296 PASS
PN 01A TDM-BUS 297 ABORT 1005
PN 01B TDM-BUS 294 PASS
PN 01B TDM-BUS 296 ABORT 1005
PN 01B TDM-BUS 297 PASS