Testing the complete configuration
Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway 271
December 2003
Testing telephones and other equipment
This section describes how to test the telephones and other equipment. Perform these tests after the
equipment has been wired to the media gateway and after the customer’s data for that equipment has been
administered. The tests are acceptance tests and provide some assurance that the system will perform
properly after installation and administration.
If problems occur or more extensive tests are required, see the maintenance book for your configuration
.
Perform these tasks to complete acceptance tests:
• Making test calls on page 271
• Testing 302C attendant console on page 271
• Testing selector console on page 272
• Testing external ringing on page 272
• Testing queue warning indicator on page 272
• Testing integrated announcement on page 272
• Testing music-on-hold on page 273
• Testing emergency transfer (Avaya S8700 Multi-Connect only) on page 273
• Testing remote access interface on page 273
• Testing terminating trunk transmission on page 273
• Testing connectivity to the LAN on page 274
• Resolving alarms on page 274
Making test calls
Make two calls from one telephone to another telephone. Make the first call by dialing a telephone and
make the second call by dialing a trunk access code and a listed directory number (LDN).
Testing 302C attendant console
Check all lamps are operational and call another telephone in the configuration.
1 Simultaneously press and hold Ringer Volume up and POS BUSY.
This puts the console in the self-test mode.
NOTE:
Releasing the buttons returns the console to normal mode.
2 Verify all lamps on display light and remain lighted.
Each row of lamps on the console lights and goes dark in sequence from top to bottom.
3 Press Start and listen for dial tone.
The green lamp associated with Idle Call Appearance lights up.
The Position Available lamp goes dark.
To Next Page
Loading...
