88 Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway
December 2003
Installing circuit packs in the G650 Media
Gateway
Circuit pack installation
CAUTION:
When handling circuit packs or any components of an G650 Media Gateway, always wear
an authorized wrist ground strap. Connect the strap to the ground connector provided on
the media gateway.
Circuit pack slot loading
1 Load all port circuit packs. See Table 3, G650 Media Gateway circuit pack placement, on page 88
for the recommended circuit pack layouts. Slots in the G650 Media Gateway are numbered from
left to right beginning with slot 0. See Figure 3, Front view of an G650 Media Gateway,
on page
69.
2 Install the TN2312BP IPSI adapter on the connector panel in slot 1 for carrier A. If you are using
duplicated IPSIs, connect another IPSI adapter in position 1 for carrier B. Connect the CAT 5
ethernet cable to the adapter to connect the G650 Media Gateway to the ethernet. If you want to
use the external alarm function, attach an external alarm cable to the IPSI adapter. Figure 14,
G650 Media Gateway IPSI adapter, on page 89 shows the IPSI adapter.
Table 3: G650 Media Gateway circuit pack placement
Circuit pack information Placement information
Circuit pack name Required or optional Slot number Required or recommended
655A power supply Required 0 Required
Redundant 655A power
supply
Optional 15 If it is present, it must be in slot 15.
TN2312BP IPSI Required A01 Required
Second TN2312BP IPSI Optional B01 If it is present, it must be in slot B01.
TN799DP (or greater
suffix) CLAN
Optional 2 Recommended
TN2302 media processor Optional 14 Recommended
TN771 maintenance/test
board
One per customer
location
Any slot —
Port circuit packs — Slots on the
left
Recommended
Trunk circuit packs — Slots on the
right
Recommended
To Next Page
Loading...
