Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway 61
December 2003
Figure 1: Equipment packed with a single G650 Media Gateway
Checking circuit packs
1 Be sure all circuit packs are fully inserted into the proper slots according to the system diagram
provided by the project manager.
Report any discrepancies in circuit pack type or quantity to your Avaya representative.
For detailed circuit pack descriptions, see the Hardware Guide for the Avaya Communication
Manager
The job aid titled Pre-Installation Information - S8700 Media Server
lists the comcodes for
equipment used with the G650 Media Gateway. If “Optional” is indicated, the equipment may or
may not be necessary, depending on the site configuration.
2 Check the any adjuncts shipped for damage and report all damage according to local shipping
instructions.
Figure notes
1 ESD ground jack
2 655A power supply
3 TN2312BP IP server interface (IPSI)
circuit pack
4 TN799DP CLAN (optional)
5 TN2302 IP media processor (optional)
FAN OR POWER FAIL
FAN AND POWER OK
AC INPUT
DC INPUT
ACTIVE RING
FAN OR POWER FAIL
FAN AND POWER OK
AC INPUT
DC INPUT
ACTIVE RING
103 4
5
6 8 9Power
2
7 11
12
13 Power
1
14
2
1
5
3 4
scdlff02 LAO 081203
2
To Next Page
Loading...
