Testing the complete configuration
276 Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway
December 2003
Figure 110: LEDs on front and back of media server
Testing the media server LEDs
You can test some of the LEDs on the front of the media server through the Maintenance Web Interface.
This makes sure that the Active/Standby and U2 LEDs (on the front of the media server) and the transmit
LED on the DAJ1 duplication memory card (on the back of the media server) are controllable and not
burned out and that the media server is not hung.
NOTE:
The U2 LED is controlled by the S8700 Media Server but does not have an assigned
function.
The other LEDs are exclusively under hardware control so will not flash during the test. See the OEM
user documentation that comes with the media server for information on those LEDs.
During the 1-minute test, the Active/Standby and U2 LEDs alternate from being on (amber) for 1 second
and off for 1 second off. The transmit LED cycles from red (on 1 second, off 1 second) to green (on
1 second, off 1 second).
Using the Maintenance Web Interface, test the LEDs on the front of the media server:
1 Under Diagnostics, click Test Server LEDs.
Figure notes
1 Power
2 Configuration fault
3 Hard drive activity
4 Network activity (CNA)
5 Service—configuration health
6 Active or standby mode indicator
7 U2 (not defined)
8 4 NIC ports (the numbers indicate their
assigned Ethernet ports)
9 LEDs for the NIC ports (some NICs may
not have LEDs)
10 LEDs for fiber optic duplication
connectivity
11 Status LED (not used)
1
SERVICE
U2
STANDBY
ACTIVE
2
1
55 44 33
22
DAI - 1
DUP
MEM
OR
Y
LINE
RECEIVE
TRANS
LINK
STAT
AVAYA
1 2
3 44 5
6
7
9
10
11
8
scdlled KLC 030502
To Next Page
Loading...
