Contents
Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway 9
December 2003
Closets 157
Satellite locations 157
Site locations 158
Station circuit distribution from equipment room 158
4-pair station circuits 159
3-pair to 4-pair station circuit distribution 159
Connected cable station adapters 164
Completing a provisioning plan 166
Installing sneak current and off premise protection 168
Installing sneak fuse panels 171
Installing the coupled bonding conductor 172
Installing coupled bonding conductor wires 172
Installing and administering the patch cord/jumper 174
Labeling expansion control carrier cable
(MCC1 Media Gateway only) 176
Connecting expansion control carrier outputs
cable (MCC1 Media Gateway only) 177
Connecting trunk pairs using concentrator cables 177
Connecting trunk pairs to media gateway
using jumper wires to establish 3-pair modularity 179
• Connecting to the IP server interfaces 181
Connecting to the internet protocol service interface circuit packs 181
Programming the internet protocol service interface circuit packs 182
Using DHCP addressing 182
Using static addressing 183
Verifying that IPSIs are translated 187
Verifying connectivity to media server 187
Upgrading IPSI firmware version (if necessary) 187
Enabling IPSI duplication (high or critical reliability only) 187
Enabling control of IPSIs 188
Verifying license status 189
• Connecting to the customer’s network 190
Avaya S8700 Media Server 190
TN799DP Control LAN 191
TN2302AP IP Media Processor 191
TN801B MAP-D LAN Gateway 191
TN2501AP Voice Announcement over LAN (VAL) 191
Important file specifications 192
Caveats 192
To Next Page
Loading...
