Avaya S8700 - Install Earthquake Protection for Avaya SCC1 Media Gateway

101
Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
May 2003
Perform this step first for all standard reliability media gateway stack installations.
1 Install the media gateway stack
• Place expansion control media gateway A (J58890N) on the floor in the position
determined when the room layout was planned.
• Set port media gateway B (J58890H) on top of expansion control media gateway
A.
• Set port media gateway C (J58890H) on top of port media gateway B.
• Set port media gateway D (J58890H) on top of port media gateway C.
2 Install 2 through 44 media gateway stacks using the instructions in step 1.
Install Earthquake Protection for Avaya SCC1
Media Gateway
Earthquake protection installs only on Avaya SCC1 media gateways.
1 Position the expansion control media gateway A (J58890N) in the position it is to occupy
when the installation is complete. Be sure it is level.
2 Using a pencil or marker and using the Front Mounting Angle as a template, mark the
locations of the two floor mounting holes.
3 Move the media gateway out of the way and drill a hole 0.5-inch (1.3 cm) in diameter
and 1.5 inches (3.8 cm) deep at the locations marked in Step 2.
4 Insert a concrete floor anchor (STARR part number 3425) into each hole.
5 Secure the Front Mounting Angle to the floor using the short hex head bolts provided.
6 Move the media gateway back into place.
7 At the rear of the media gateway, remove the two hole plugs from the bottom of the
media gateway. See ‘‘Media Gateway Earthquake Mounting — Rear View’’ on page
102.
8 Insert a pencil or marker through the holes in the bottom of the media gateway and mark
the floor directly beneath each hole.
9 Move the media gateway out of the way and drill a hole 0.5-inch (1.27 cm) in diameter
and 1.5 inches (3.8 cm) deep at the locations marked in Step 10.
10 Insert a concrete floor anchor (STARR part number 3425) into each hole.
11 Move the media gateway back into place and align with the Front Mounting Angle.
12 Attach the media gateway to the Front Mounting Angle using the four supplied #12-24 x
1/2-inch (1.27 cm) thread-forming screws. See ‘‘Front Mounting Angle Location’’ on
page 103.
13 Lay the supplied Stiffener on the bottom rear of the media gateway and align with the
holes in the bottom of the media gateway. See ‘‘Media Gateway Earthquake Mounting
— Rear View’’ on page 102.
14 Slide a nylon washer onto each of the two supplied long hex head bolts.