272
Migrating to an Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Completing the Installation Administration
May 2003
Completing the Installation
Administration
This section covers the following tasks:
• ‘‘Verify translations’’ on page 272
• ‘‘View alarms’’ on page 275
• ‘‘Enable and disable Ethernet switch ports’’ on page 276
• ‘‘Back up the media server to PCMCIA flashcard’’ on page 277
• ‘‘View alarms’’ on page 279
• ‘‘Set product ID’’ on page 279
• ‘‘Add INADS phone numbers’’ on page 280
• ‘‘Enable alarms to INADS via modem’’ on page 280
• ‘‘Register the system’’ on page 281
Verify translations
The following administration is done on a computer used to access the active media server
using a terminal emulation application.
1 Type list configuration all and press Enter to view all the administered circuit packs in
the system.
2 Type list ipsi and press Enter to verify the location of the IPSI circuit packs.
3 Check the administration status on the following items:
• list station
• list trunk-group
• list hunt-group
NOTE:
Even though you set the date, time, and time zone through the Web interface on the S8700
Media Server, you must also set the daylight savings time rules and locations and verify
the date and time through SAT commands.
Set daylight savings time rules
The following administration is done on a computer used to access the active media server
using a terminal emulation application.
You can set up to 15 customized daylight savings time rules. If you have media gateways in
several different time zones, you can set up rules for them on a per-location basis. A daylight
savings time rule specifies the exact time when you want to transition to and from daylight
savings time. It also specifies the increment at which to transition.
To Next Page
Loading...
