188
Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Connecting to the IPSIs
May 2003
Connecting to the IPSIs
Prerequisite: The media gateways must be installed, connected to each other, and powered up.
This section covers the following tasks:
• ‘‘Connect the Ethernet switch cables to the IPSI circuit packs’’ on page 188
• ‘‘Program the IPSI circuit packs’’ on page 200
• ‘‘Using DHCP addressing’’ on page 201
• ‘‘Using static addressing’’ on page 203
• ‘‘Verify that IPSIs are translated’’ on page 206
• ‘‘Avaya MCC1 Media Gateway’’ on page 188
• ‘‘Avaya SCC1 Media Gateway’’ on page 188
• ‘‘Upgrade IPSI firmware version (if necessary)’’ on page 207
• ‘‘Enable control of IPSIs’’ on page 207
• ‘‘Verify License Status’’ on page 208
Connect the Ethernet switch cables to the IPSI
circuit packs
NOTE:
Once the IPSIs are connected to the control network, they may alarm if the firmware is not
the most current. The alarm will automatically go away once the IPSI firmware is
upgraded.
Avaya MCC1 Media Gateway
Connect one end of the GREEN CAT5 straight-through cable to the IPSI adapter on the back of
carrier A. The other end is connected to the next available port on the Ethernet switch. If not
already connected, connect it.
If high or critical reliability, connect one end of the RED CAT5 straight-through cable to the
IPSI adapter on the back of carrier B. The other end is connected to the next available port on
the Ethernet switch for CNB. If not already connected, connect it.
For a connectivity guide refer to Getting Started with the Avaya™ S8700 Media Server with an
Avaya™ MCC1 or SCC1 Media Gateway.
Avaya SCC1 Media Gateway
For a general connectivity guide refer to Getting Started with the Avaya™ S8700 Media Server
with an Avaya™ MCC1 or SCC1 Media Gateway.
Use the following detailed steps to connect the Ethernet cables at the SCC1 media gateway.
To Next Page
Loading...
