Avaya S8700 - Test Time Division Multiplexing Bus for each Port Network; Test Expansion Interface Exchange for each; Port Network (S8700 Multi-Connect Only)

295
Migrating to an Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Testing the Complete Configuration
May 2003
Test Time Division Multiplexing bus for each port
network
Check each TDM bus for each Port Network (PN) in the configuration.
1 Type test tdm port-network 1 and press Enter.
2 Verify a test results screen similar to "Sample Test Results for TDM Bus Port Network 1"
is displayed.
3 If result is FAIL for any test, check the connectors of the TDM bus cables in PN 2.
4 Repeat these steps for each PN to check the TDM bus cables.
Sample Test Results for TDM Bus Port Network 1
Test Expansion Interface Exchange for each
port network (S8700 Multi-Connect only)
If the configuration is critical reliability, test the expansion interface exchange for each Port
Network (PN).
1 Type status port-network number <1-64> and press Enter.
This displays the standby expansion link. See "Sample of Port Network Status before
Expansion Link is Set—S8700 Multi-Connect".
2 Type set expansion-link UUCSS, where UUCSS is one of the cabinet, carrier, and port
locations of the standby expansion link, and press
Enter.
3 Verify the bottom of the screen displays:
Command successfully completed
4 Type status port-network number <1-64> and press Enter.
A screen similar to "Sample of Port Network Status after Expansion Link is Set—S8700
Multi-Connect" displays.
5 Verify that the MODEs of the expansion links have changed.
6 If any problems are indicated, check the TDM cables and the inter-cabinet cables (ICC)
in the associated port network.
test tdm port-network 1
TEST RESULTS
Port Maintenance Name Alt. Name Test No. Result Error Code
PN 01A TDM-BUS 294 PASS
PN 01A TDM-BUS 296 PASS
PN 01A TDM-BUS 297 ABORT 1005
PN 01B TDM-BUS 294 PASS
PN 01B TDM-BUS 296 ABORT 1005
PN 01B TDM-BUS 297 PASS