Avaya S8700 - Customize the Active Media Server; Start Terminal Emulation

55
Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Customize the Active Media Server
May 2003
Customize the Active Media
Server
For SAT commands, use a terminal emulation application, such as Avaya™ Terminal Emulator
or HyperTerminal. You can also use Avaya Site Administration, part of the Avaya™ VisAbility
Suite, which you can purchase from Avaya.
NOTE:
You must use Release 1.11 or a later version of Avaya Site Administration to be able to
administer new features in Release 1.3 of Avaya™ Communication Manager.
NOTE:
For SAT commands you must be on the active media server.
List of Tasks:
• ‘‘Start terminal emulation’’ on page 55
• ‘‘Input translations’’ on page 56
• ‘‘Reset media server’’ on page 56
• ‘‘Add media gateways’’ on page 56
• ‘‘Administer and enable the IP Server Interface’’ on page 57
• ‘‘Add IPSI translations to Communication Manager’’ on page 58
Start terminal emulation
NOTE:
Avaya™ Terminal Emulation and HyperTerminal are supported terminal emulation
applications. Terranova is not supported.
1 On the services laptop open a VT-100 terminal emulation session using an application
such as Avaya Terminal Emulation.
2 Administer the terminal emulation port settings:
• 9600 baud
• No parity
• 8 data bits
• 1 stop bit
• No flow control
3 Log into the active media server as craft.