112
Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
May 2003
Connect Battery Cabinet
!
CAUTION:
Power is present in the media gateway even if the AC power cable is unplugged. Turn off
the main circuit breaker on the front of the media gateway when procedures require ALL
power to be removed from the media gateway.
Connect the DC Battery cabinet to the DC Power cabinet.
‘‘DC Battery to DC Power cabinet Connections’’ on page 112
shows how to make typical
connections from the DC Battery cabinet to the DC Power cabinet.
DC Battery to DC Power cabinet Connections
Connect Optional Battery Leads
To prevent the internal batteries from discharging, the Control media gateway is shipped with
the battery leads disconnected.
1 Set the circuit breakers OFF. See ‘‘Expansion Control Media Gateway Battery Location
— Right Side’’ on page 113.
2 Connect the battery leads. The battery is near the top of the carrier toward the front-right.
The battery leads are located next to the battery and are accessible from the front of the
media gateway.
Figure notes
1 DC Power cabinet
2 Connect Red DC Power Cable to -48
VDC Return Bus
3 Connect Black DC Power Cable to -48
VDC Bus
4 Inset Applies to -48 VDC Buses and -48
VDC Return Buses
5 Battery cabinet
6 DC Power Cables (Red and Black)
pwrdist5 RBP 052896
To Next Page
Loading...
