Avaya S8700 - Update System; Verify Media Server 2 Connection to Customers LAN (if Provided)

46
Migrating to an Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Configure Media Server 2
May 2003
Update System
1 When the Update System page displays, click Continue to update the server.
NOTE:
The media server is not configured until you click Continue on the Update System page.
The Update System screen displays each configuration task as it completes it. The last
line says "System modifications completed."
Verify media server 2 connection to customer’s
LAN (if provided)
Refer to the filled-out job aid titled Pre-Installation Network Planning Forms—Avaya™ S8700
Media Server for information on how to access a computer on the customer’s network.
1 Connect a customer-supplied CAT5 straight-through cable from media server 1, port 5
(Eth4), to the customer’s LAN. Refer to Getting Started with the Avaya™ S8700 Media
Server with Avaya™ MCC1 or SCC1 Media Gateway.
NOTE:
For security reasons, you may not be able to ping out to the customer’s network. If you are
not able to, look at the LAN security settings, particularly all/icmp.
2 Under Security click Set LAN Security
3 If all/icmp is not checked, check both boxes to the left and click Set Security.
4 Under Diagnostics click Execute Ping.
5 Type in the IP address of a computer on the network.
6 Click Execute Ping.
7 Verify that the ping was successful, indicating that the media server is connected to the
customer’s network.
8 Type in the host name, if DNS is administered, of a computer on the network.