57
Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Customize the Active Media Server
May 2003
2 Fill in the appropriate carrier types for each media gateway.
Administer and enable the IP Server Interface
NOTE:
Do this procedure only if the translations were not input earlier.
The following administration uses the services laptop computer connected to the active media
server and uses a terminal emulation application.
NOTE:
This procedure enables the IPSI circuit packs and allows them to control the port
networks.
1 Type change system-parameters ipserver-interface and press Enter.
2 Verify that the Primary and Secondary Subnet Addresses are correct.
add cabinet 1
CABINET
CABINET DESCRIPTION
Cabinet: 1
Cabinet Layout: five-carrier
Cabinet Type: expansion-portnetwork
Number of Portnetworks: 1
Survivable Remote EPN? n
Location: 1
Cabinet Holdover: A-carrier-only
Room: Floor: Building:
CARRIER DESCRIPTION
Carrier Carrier Type Number Duplicate
C not-used PN 01
B port PN 01
A expansion-control PN 01
X Fan
D not-used PN 01
E switch-node SN 01 03E
change system-parameters ipserver-interface Page 1 of 1
IP SERVER INTERFACE (IPSI) SYSTEM PARAMETERS
SERVER INFORMATION
IPSI Host Name Prefix: vodka
Primary Control Subnet Address: 198.152.254. 0 *
Secondary Control Subnet Address: 198.152.255. 0 *
OPTIONS
Switch Identifier: A
IPSI Control of Port Networks: enabled
To Next Page
Loading...
